Securifi Community Forum

Securifi Products => Almond+ => Topic started by: NeilH on September 21, 2014, 07:33:06 am

Title: Desk stand & wall mount
Post by: NeilH on September 21, 2014, 07:33:06 am

Just got my unit so ready to set-up. I understand that it should not be operated horizontally, laid on the 4 rubber feet, but vertically using either the Desk stand or wall mount. Long term I will wall mount but, for now I need to use the desk stand.

Could somebody just confirm that the "snap-in" for these adaptors is not a one-way thing - it also easily snaps back-out - ie, if I attach the desk-stand now, can I easily remove the desk stand to fit the wall mount (& vice-versa).

I would imagine that this IS the case - but best to be sure before I attach the stand  ;o)

TIA

Title: Re: Desk stand & wall mount
Post by: TEmp on September 21, 2014, 07:45:37 am

Hehe, i was worried about this as well, but i can assure you it will snap out again!

Title: Re: Desk stand & wall mount
Post by: LGNilsson on September 23, 2014, 11:08:57 am

They're quite easy to remove, so no worries.