Securifi Community Forum
Securifi Products => Almond and Almond A1A => Topic started by: Mike142 on October 04, 2014, 08:14:07 pm
-
Hello,
I've had the almond for a few weeks now, my 7 year old Trendnet was just not cutting the mustard anymore. Worked beautifully out of the box, however, I have a bizzarre problem that only started a week and a half ago where the router stops all wireless traffic. My desktop is plugged into the LAN connection and continues to work fine, but all wireless stops. Nothing to indicate when I log in through the IP address on my wired computer that there is any problem, however the log is full of things like this:
Oct 5 00:02:00 almond user.warn kernel: d9d, flush one!
Oct 5 00:02:00 almond user.warn kernel: da1, flush one!
Oct 5 00:02:00 almond user.warn kernel: da5, flush one!
Oct 5 00:02:01 almond user.warn kernel: dad, flush one!
Oct 5 00:02:01 almond user.warn kernel: 83f, flush one!
Oct 5 00:02:01 almond user.warn kernel: db1, flush one!
Oct 5 00:02:01 almond user.warn kernel: db3, flush one!
Oct 5 00:02:01 almond user.warn kernel: 843, flush one!
Oct 5 00:02:01 almond user.warn kernel: db8, flush one!
After it started doing it, I did a full factory reset and then set it back up again, just to have it start doing it again immediately. Then, I downloaded the latest firmware and updated that as well, still no change. I'm using it in router mode, CAT5 to the cable modem, with two wired connections: my desktop and a Buffalo NAS drive.
Ideas?
Thanks,
Mike
-
well, now the wireless is just stuck on dead-slow. Tried restarting, factory reset and reload latest firmware and reload config, factory reset and only change SSID and password, nothing is working... I'm hard wired right now on my desktop and it is working fine.
-
Nobody else has this issue? I've also Emailed support, but no response there either...