Securifi Community Forum

Securifi Products => Almond+ => Topic started by: fldude on January 10, 2015, 05:09:57 pm

Title: Changing DHCP range
Post by: fldude on January 10, 2015, 05:09:57 pm

I have changed the default IP address, and would like to change the range to avoid adding all the static assignments manually.  When i go to change the start range from 1 to 50, I get an error
"DHCP end ip should be greater than the start ip".  Clearly it is, as the end ip is still 250.  I tried reversing the order (pretending the web page was wrong) and put int 250, then 50, and I could not connect back to the wireless to configure it without rebooting.  What am I doing wrong?

Title: Re: Changing DHCP range
Post by: eldaria on January 10, 2015, 07:28:18 pm

What firmware are you on?

There is a bug in one of them where someone swapped a > and a < so it is not possible to set it correctly.

Title: Re: Changing DHCP range
Post by: fldude on January 29, 2015, 09:17:14 pm

Where to I find the firmware version?  All I can seem to find is the software version.

Title: Re: Changing DHCP range
Post by: LGNilsson on January 29, 2015, 09:25:47 pm

Same thing, apologies if that wasn't clear.