Securifi Community Forum

Securifi Products => Almond+ => Topic started by: Mishakim on February 15, 2015, 12:03:56 pm

Title: R70 fobs still not quite right in rules
Post by: Mishakim on February 15, 2015, 12:03:56 pm

Rules for the securify fobs still don't quite match the actual fobs or the sensor state. Now, the rules show five buttons, arm, disarm , perimeter, panic, and emergency, but there are only four buttons. Three of those match what the sensor tab reports when pressing the buttons on the fob, but neither panic nor emergency (nor anything else) come up when pressing the fourth button (star).  Also, it would be nice if the first two names actually matched the button labels (lock/unlock, not arm/disarm)

Title: Re: R70 fobs still not quite right in rules
Post by: LGNilsson on February 16, 2015, 03:33:52 am

Well, technically it is arm/disarm, as it's meant to arm/disarm your "alarm" and this is also why the third is arm perimeter as it's sort of the night mode where only certain sensors are supposed to be armed so you don't trigger an alert/siren etc. because you went for a glass of water in the middle of the night.

I'm not sure about the fourth button, I've asked them about this as well and I'm not quite sure what's going on here. I'll check again.

Title: Re: R70 fobs still not quite right in rules
Post by: Mishakim on February 16, 2015, 09:45:39 am

Thanks.  I understand the reason for the names, I'm just saying since the buttons show locks, that's what I'd call them in the UI. Also the icons in the UI don't match the buttons for those two, but do for perimeter (key with check or x, vs padlock open or closed