Securifi Community Forum
Securifi Products => Almond+ => Topic started by: jnowland on April 22, 2015, 07:45:45 am
-
I have noticed that after the recent firmware update, my Securifi Motion Detector no longer triggers the light for which I have a rule set for. I have a rule stating that between 7pm and 11:59 pm, if motion is detected, turn on outside light (Linear WS15-Z). I also have a rule set for midnight to 6:30 am due to not being able to set a between rule past midnight. Motion is detected on the device, but the light does not switch on. I have another rule to turn off an inside light if said light is on and motion is detected between 6am and 6:30am for when I leave for work to turn off the lamp I normally use in the am. That rule triggers and the lamp (GE Wink) goes off.
-
@ jnowland,
We tested the same scenario with different Z-wave device and it was working fine. However, at present we don't have this Linear WS15-Z to check it, but we are going to receive it soon. Once we receive it, we would do a proper testing and would let you know. Meanwhile, it would be very helpful, if you could send the pictures of the rules which you have created.
-
Thank you Ashok, I will post the rules I set up once I get home. As a prelude however, the issue came down to the setting of the last part of the rule where I requested that after 180 seconds, the light turn off. Every time I set it up, the 180 seconds would not save. I had to go back in and sort of mess with the rule as I set it to get the 180 seconds to stick. Hard to explain but first, the entering of the 180 seconds is a pain. The rule does not allow for the simple entering of the number 180. I have to click the arrow until it reaches 180, or copy the number 180 from somewhere else and paste it in after I somehow get the block to highlight. Again, hard to explain. If I simply clicked save after that, the 180 would not save. I have to click the arrow up or down to a number higher or lower and then click back to 180, then hit save. After that the 180 saves. Once I got htis all done, the light runs on and then off properly. Without the 180 of course, the switch was being told to turn off right away after the motion turned it on. Perhaps someone can look into this? Again, I will post the rule once I get home and can access my rules. Thanks again.
One more thing, please try to duplicate the other issue where using the A+ UI, the switch will not turn on by clicking "on". I have to use the dimmer bar on the UI to get the light to turn on. Not a big issue as I do not use the UI to turn lights on and off, but just stating it appears to be a glitch.
-
@ jnowland,
You are most welcome. I just tried doing the same thing at my end and was able to enter the values (180 seconds) manually with out any concerns on rules page.
Coming to the other issue with dimmer, we were able to replicate it and would be taken care through next firmware.