Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: jnowland on April 25, 2015, 10:19:43 pm
-
After updating to the 72 firmware, I wasn't able to operate my Linear switches via a rule. I removed the switches and re-added them, but they do not even respond via the A+ UI, nor the rules. When I re-added them, I noticed that I was asked to choose what type of switch I was adding, multilevel, roller someting or another, and other. Anyway, does anyone know if these switches are still supported? Strange because I can operate the switches via the app, just not on the A+ U, which explains why the rules don't work. Anyone have any suggestions?
-
Mine are still working. Not sure what would be causing the problem if you were able to add them AND control them via the App... very strange.
Reboot?
-
After much troubleshooting, I discovered that I can turn in the switches via the Web UI only by using the dimming arrow and not by pressing on or off. On the rule, I noticed that in part of the rule where I had the light, which was turned on by motion subsequently turned off after 180 seconds, the 180 part somehow dropped off. Thereby the switch was seeing the off command right after the turn on command, messing the whole thing up. It took a whil, but I finally got it fixed.
-
Good point... If someone is having trouble it is good to check their Rules (if any) also... Something everyone should keep in mind.