Securifi Community Forum

Securifi Products => Almond+ => Topic started by: ggaspari on July 14, 2015, 10:10:56 am

Title: DMZ
Post by: ggaspari on July 14, 2015, 10:10:56 am

Hi guys,

I'm trying to set up a DMZ so I can access my PC from outside on ports 8080, 8081 and 9091
So far I did this

(http://i.imgur.com/8MvHIql.png)

This should work, but I cannot access it - Says "can't connect"

What else should I do? I was using a tomato based firmware and am new to OpenWRT

Title: Re: DMZ
Post by: fillibar on July 14, 2015, 10:21:55 am

Is the DNS ready for accessing your network? Obviously going to that IP would not work.

Did you try port forwarding? I use that when I only need a few ports and that works fine. DMZ opens up everything to the target.

Title: Re: DMZ
Post by: kbtn on July 14, 2015, 03:11:18 pm

You can use a DDNS service and/or utilize port forwarding and still maintain some security to your network. 

Title: Re: DMZ
Post by: Fire69 on July 14, 2015, 03:57:25 pm

I would recommend DMZ either if you just want to access your pc from the outside.  You are creating a huge risk that way.
Just check what ports you need and then set up port forwarding.
And a DDNS is also nice in that case :)