Securifi Community Forum

Securifi Products => Almond+ => Topic started by: Stuntman on September 08, 2015, 01:12:20 pm

Title: Aeon Labs DSC06106-ZWUS can't find or pair
Post by: Stuntman on September 08, 2015, 01:12:20 pm

I have a Aeon Labs appliance switch that I removed from my Almond+ via the LCD, then wanted to re-add it.. unfortunately I can no longer seem to do so.. the switch behaves as if it thinks it is still paired (solid blue light on the the DSC06106), but the Almond+ just pops up the info screen about pushing the pairing button when I attempt to add a 'new sensor'..  any ideas on how to either reset the Aeon device or perhaps allow the Almond+ to see it?

Thanks!

Title: Re: Aeon Labs DSC06106-ZWUS can't find or pair
Post by: grouter on October 28, 2015, 08:47:38 pm

I saw somewhere on this forum to put the A+ in remove mode and then triple-click the Aeon button to remove it and put it in flashing mode.

Every time I need to add this device it's hit or miss. The above trick does work for me to remove it, and most of the time it will pair up when it's flashing after doing the remove bit. I usually end up unplugging at some point before the thing will add.