Securifi Community Forum

Sensors and Home Automation => Home automation => Topic started by: lgkahn on September 12, 2015, 02:16:49 pm

Title: SmartThings SmartSense Temp/Humid
Post by: lgkahn on September 12, 2015, 02:16:49 pm: SmartThings SmartSense Temp/Humid pairs fine recognized as temp sensor. But shows unsupported in all interfaces
Title: Re: SmartThings SmartSense Temp/Humid
Post by: lgkahn on September 12, 2015, 03:03:14 pm: More info.. even though it says unsupported device. In touch screen interface it shows temp and it Android app it says unsupported device also but if u view logs you can see temp reading, in Fahrenheit, but about 7 degrees too high.
Title: Re: SmartThings SmartSense Temp/Humid
Post by: lgkahn on September 12, 2015, 09:53:39 pm: Sensor settled down after a few hours and now reads within a half a degree if what the thermastat is set to. This is in logs only still unsupported. Seems to only log changes if 2 degrees Fahrenheit or more. Not sure if that is a sensor or a+ setting.
Title: Re: SmartThings SmartSense Temp/Humid
Post by: lgkahn on September 13, 2015, 07:18:58 pm: I recant.. it doesnt work reliably. Once it gets down the an accurate temp. There are no further readings in the logs ..I have removed and repaired it multiple times. If I out it in the freezer or outside it stays at 74 degrees. Does anyone know off a temp sensor that does work under a+ v80. I need to monitor an empty house and make sure pipes don't freeze. Thanks.
Title: Re: SmartThings SmartSense Temp/Humid
Post by: rpr69 on September 14, 2015, 04:08:00 pm: I have no comment other than to say that I believe you can edit your own posts, as opposed to replying to yourself.