Securifi Community Forum

Securifi Products => Almond+ => Topic started by: Espionage724 on May 11, 2016, 10:13:02 pm

Title: How to enable IPv6 on Comcast?
Post by: Espionage724 on May 11, 2016, 10:13:02 pm

It didn't seem to work out-the-box and I don't see any obvious instructions anywhere that state how to enable it, but it does look like there's support for IPv6 from the OpenWRT interface.

Is there any way to be able to use IPv6 across both LAN and WAN? My ISP is Comcast and I use some Motorola Surfboard modem (it's DOCSIS 3).

I have a TP-Link router that out-the-box worked with IPv6. Here's some values (some values redacted):

Quote

WAN
Connection Type: Dynamic IPv6
Connection Status: Connected
IPv6 Address: 2001:558:xxxx:62:6064:xxxx:xxxx:152d /64
IPv6 Default Gateway: fe80::deeb:94ff:feb4:xxxx
Primary IPv6 DNS: 2001:558:feed::2
Secondary IPv6 DNS: 2001:558:feed::1

IPv6 LAN
IPv6 Address Type: RADVD
Prefix Length: 64
IPv6 Address: 2601:545:xxxx:73ba:xxxx:1fff:febd:xxx

Title: Re: How to enable IPv6 on Comcast?
Post by: Ashok on May 23, 2016, 07:22:55 am

@ Espionage724,

We have not added the support yet for the IPV6.

Title: Re: How to enable IPv6 on Comcast?
Post by: shofixti on June 14, 2016, 05:54:21 am

Quote from: Ashok on May 23, 2016, 07:22:55 am

@ Espionage724,

We have not added the support yet for the IPV6.

Ashok, can you tell us when IPv6 will be fully supported? I just went back to look at the Kickstarter page (a Kickstarter I backed), and it's right there on the main page:

Quote

Is Almond+ IPv6 compatible?
Yes