Securifi Community Forum

Securifi Products => Almond+ => Topic started by: lmmmmm on May 18, 2016, 01:57:16 pm

Title: Getting rid of orphaned devices
Post by: lmmmmm on May 18, 2016, 01:57:16 pm

What is the best method to remove individual sensors that are not available so they can be removed from the A+

Title: Re: Getting rid of orphaned devices
Post by: Ashok on May 18, 2016, 04:25:10 pm

@ immmmm,

Under the connected sensors, on each and every sensor you would see an option "Remove" which would allow you to remove the sensor only from the Almond+.

Title: Re: Getting rid of orphaned devices
Post by: lmmmmm on May 18, 2016, 06:00:41 pm

so, what's the difference between using the 'add sensor' UI to remove a sensor and the remove feature when editing a sensor???

Title: Re: Getting rid of orphaned devices
Post by: Ashok on May 18, 2016, 10:48:32 pm

@ Immmmm,

If you would like to remove the sensor from the Almond+ and network from the sensor, we use the single remove option under Add sensor. If you are using the remove option through the connection sensors then it would be removed only from the Almond+ and if it is a Zigbee sensor, you have to reset it to add it back for Z-wave need to follow the removal procedure before connecting it.