Securifi Community Forum

Sensors and Home Automation => Home automation => Topic started by: itzfry on June 04, 2016, 08:46:34 am

Title: Error code on Multi Sensor
Post by: itzfry on June 04, 2016, 08:46:34 am

I know this isn't on the supported list but the functionality for motion, temp, and humidity work.  The LUX (which is what I want to use it for) does not.  Any idea of the error codes and if there is a work around to get this to work on the almond - perhaps using another device type, etc?

Error code after adding device:  user.info sysinit: WRITE ERR: ep 01 clus 0019 attr 0006 not supported^M

Model:  http://www.amazon.com/Aeon-Labs-Aeotec-Z-Wave-Multi-Sensor/dp/B00S68NUSW

Thanks in advance!

Title: Re: Error code on Multi Sensor
Post by: Ashok on June 04, 2016, 09:26:28 am

@ itzfry,

May be through changing the parameters, we may be able to do something on this, try to send the log files.

Title: Re: Error code on Multi Sensor
Post by: itzfry on June 05, 2016, 09:37:05 am

Thanks.  I kept at it and got the device to add - all values are now reporting.  Partially, I may have been inpatient as it seems either a) the device only tests LUM % every x amount of minutes or b) the Almond is only processing it correctly with a delay. 

Before sending the logs, perhaps you could help with 2 questions:

A)  the device is ranging LUM % based on 0-200%.  Is this normal for devices?  Seems the rules engine maxs at 100%. I assume an issue.
B)  Regarding rules on sensors, how does the logic work - when something is above or below?  For things like temp and lum, it doesn't make sense for a single value but more of a range or > or < values..

I assume the answer of atleast the first question, will still require me to send logs but wanted to ask before doing so.

Thanks Secruifi Team!

Title: Re: Error code on Multi Sensor
Post by: fillibar on June 05, 2016, 11:22:33 am

Is there a chance the value is going to 254? That would be an 8 bit value (pretty common).

As for the way it works... At this time it is only an exact value. This is a limitation of the current software, although there was mention lately about maybe the next version (or some upcoming one) will have >< support.

Title: Re: Error code on Multi Sensor
Post by: itzfry on June 05, 2016, 01:04:44 pm

Thanks, perhaps - I will need to crank up directly light further to find out.  The problem is the rules only allow 0-100%, so there is the underlining issue.

If there is no range, I think there is no value in this sensor on the almond network.  Hitting an exact % of light will be extremely tough.  Same situation for temperature, humidity, etc too. 

Anyone else have any advice here?