Securifi Community Forum
Securifi Products => Almond+ => Topic started by: scroder on October 16, 2016, 02:13:35 pm
-
I have been using my Iris Garage Opener (linear) for probably 10 months without a hiccup. It was setup with one of the older firmwares then updated to 89 where it continued to work. I had an issue with it not responding last week so I deleted it from the Almond and did a reset on the opener. Not it wont pair at all! Almond says adding sensor when I pair it then switches to saying still trying to add then it just goes to the normal add screen. I have tried it at least 15 times now and it no longer works. I use this a ton due to contractors working at my house and I need to get it working again. Any ideas??
Dave
-
Got it to finally pair and thought I was done! Nope, now the sensor on the app and computer just says stopped all the time. Never changes and doesnt respond to commands. Any ideas?
-
Is it nyce tilt sensor?
-
When you deleted it did you remove it using the remove in the add sensor section or in the advanced configuration settings of the device? I would recommend doing the first. Then doing a factory reset of the garage door opener device. Then adding it again.
Basically "starting it from scratch" for the opener just to make sure.
-
When you deleted it did you remove it using the remove in the add sensor section or in the advanced configuration settings of the device? I would recommend doing the first. Then doing a factory reset of the garage door opener device. Then adding it again.
Basically "starting it from scratch" for the opener just to make sure.
I have done 2 factory resets on the garage sensor. It still only says stopped on the app and doesn't respond to any commands. I removed it from the add sensor section as I am not sure where to look in advanced configuration settings.
-
Change the battery in the tilt sensor and re-pair. This was what happened to mine.