Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: grouter on December 05, 2016, 05:02:06 pm
-
Trying to install an NYCE-3014 Gen 1 Tilt Sensor...
It's on the supported list for the A+ but will not pair via the LCD or Web GUI (association timed out/failed).
https://wiki.securifi.com/index.php?title=List_of_compatible_sensors_-_Almond%2B_2014
It's also on the supported list for the A3, but pairs incorrectly and shows as an Occupancy Sensor with Temp and Humidity.
https://wiki.securifi.com/index.php?title=List_of_compatible_sensors_-_Almond_3
Thanks
-
@grouter:
I have 3 of these. One works fine on my Almond 3 and previously worked on my Almond+, but another two always show as the Occupancy Sensor you are seeing (with invalid values). Not sure what is wrong, they are all the same model/hardware version.
-
@grouter:
I have 3 of these. One works fine on my Almond 3 and previously worked on my Almond+, but another two always show as the Occupancy Sensor you are seeing (with invalid values). Not sure what is wrong, they are all the same model/hardware version.
Makes me think it is a different firmware.
-
Yeah, unfortunately it is basically impossible to tell about that. I had problems with my first one because the instructions provided did not actually match up. I tried both sets with these two "new" ones in case it would help with no luck. I sent the logs when I first saw this. Hopefully it will be looked at sometime. They are neat little things. I planned on using 2 (the one that already works and one of the new ones) for our garage doors as intended. The other I though I might mount on the cat door to see how often they are in and out. Or other such uses like that.