Securifi Community Forum

Sensors and Home Automation => Home automation => Topic started by: Advanced on February 05, 2018, 06:32:34 am

Title: Delay in z-wave response
Post by: Advanced on February 05, 2018, 06:32:34 am

Super delay in z-wave response can reach 30-40 sec to open or close actuator and 5-6 sec to show that motion sensor detected or not after the action

we are using Fibaro Motion sensor QTY 4 , Fibaro Wall Plug QTY 1, Fibaro Double relay QTY 1

we are facing a huge delay from pressing on/off from Web UI or Mobile to Switch Plug actually very slow response

we did make rule that if motion detected and in away mode switch on the double relay but there is a delay that is not accepted at all


pls advise back ASAP

Title: Re: Delay in z-wave response
Post by: lucasrangit on March 09, 2018, 05:41:47 pm

I have recently noticed this as well. Even before I updated from AP2-R092 to R093. The motion sensor LED blinks quickly for a few seconds. I believe this means it is communicating.