Hard Drive Space remaining in Windows?

[Kazy]

Hello!

I just got my Almond+ today, and hooked up a 4TB USB hard drive to it.  The hard drive is formatted to NTFS, and I want to map it to a network drive in Windows.  I've been able to do this, but it just shows a red bar where it usually shows how much space is available. Anyway to make it so I can see how much space is remaining in Windows?  I'm using Samba.

Thanks!

[LGNilsson]

I'm honestly not sure if the version of Samba we're currently using supports 4TB drives.
We're working on getting this updated though, but it'll most likely take a month or two before that'll be out in a new firmware.
I'm assuming you're on firmware R065, as we did have some issues with this on the older firmwares.

[robh5791]

I had a smaller USB drive plugged into and mapped through the Almond+ and it shows the same red bar on my windows laptop. I am able to read and write but the space used and available does not show. I think it was a 16 gb USB drive and it definitely shows the space when plugged directly into a USB port.