Great Work! Nice to finally see some automation features.
A few items of note with initial playing (Some may have already been covered). Using PIRs, Window/Door Senor and Key Fob purchased with the Almond+ and an Aeotec inline dimmer.
1. Sensors did not show on web interface after update, required restart of router, software request for the router to reboot resulted in a hang, had to physically pull the power.
2. When setting Between times, both times must be on the same day ( I can't set a light to come on between 7PM and 6AM it returns Īnvalid Time, 6AM to 7PM is vaild).
3. At the moment it appears that the rule is being run everytime the trigger is true, without terminating the already running instance of the rule.
I have a PIR and a Light. When there is moment I turn on the light, wait for 180 seconds, then turn the light off. At the moment when I walk into the room the light will turn on (good) if there is only 1 trigger this is good, if I stop moving, then move again the rule is triggered again, turning on the light (which is already on) then the first timer ticks over and turns the light off, then the motion turns the light on again. which is about when the 2nd rules timer turns the light off again etc... My desk lamp has been flashing at me for the past 5 minutes :?
Suggestions
1. It would be nice (as mentioned by another user) to prioritize rules, so a light staying on for security reasons will always stay on if its triggered by the door switch. regardless if somebody has triggered a PIR for which the same lamp is used as a convenience/safety lamp.
Keep up the great work,
Shane