Added two more Linear WD500Z dimmers today, I have 4 total. Was having problems connecting the new ones, so tried "remove all" devices in the Almond+ UI. Hoping start-over would help. Apparently a really bad idea. Now, cannot get any Dimmers to connect to Almond.
- Tried the 'purging ghost sensor' instructions - did not help.
- I was able to re-connect the Peanut plug and a power outlet, so some devices are connecting to Almond. Just not the dimmers.
- completely un-powered the dimmers with their power disconnect toggle, turned back on then tried pairing again. No dice
- also tried cutting the circuit breaker, and restarting them. No dice.
- re-started the Almond and tried steps above again. Still no dimmers
Thanks in advance for help you can offer. I'm really stuck
best regards
Rob