So have been testing the new firmware. Saw the next update "Manual updates and user codes for Schlage door lock are implemented." So I tried adding user codes to my Schlage FE599NX and the only thing that happened is that I lost one of the 2 default codes. Here is the info I have
Almond+ on latest firmware R70
Schlage FE599NX
1.- Went to sensors on the webgui
2.- Clicked on user code 2
3.- Added a pin and clicked on save (a saving message appears and then disappears)
4.- The code didn't work.
5.- Tried using the original code and it didn't work.
6.- Going to the webgui it says again that a code is unassigned.
