Choose style:

Author Topic: A way to set Z-wave device parameters from Almond+  (Read 1134 times)

0 Members and 1 Guest are viewing this topic.

Offline sfalc

  • Backer
  • *
  • Posts: 167
  • Thanks: 0
  • Registered : 11/09/2014
    YearsYearsYearsYears
A way to set Z-wave device parameters from Almond+
« on: March 26, 2015, 12:51:36 pm »
Per subject. It would be a very useful feature, quite a lot of Z-wave devices utilises settable parameters.
Initially this could be from the shell over SSH.
Almond+ with 2 dimmer switches, 2 binary on/off switches, 1 Qubino Flush dimmer, 1 Aeontec micro dimmer, 1 Fibaro Dimmer 2, 1 Lightify RGBW bulb, 2 Lightify Flex RGBW Led strip, 1 WeMo Bulb, 1 Fibaro magnetic door sensor, Vision PIR & temperature sensor.

Offline lucasrangit

  • Newbie
  • **
  • Posts: 24
  • Thanks: 0
  • Registered : 28/02/2015
    YearsYearsYears
Re: A way to set Z-wave device parameters from Almond+
« Reply #1 on: March 09, 2018, 05:18:35 pm »
This can be done via the LCD UI now.

However, it would be nice to support listing the known parameters and current values. Also, when the set fails, it doesn't give very much to debug with. Is there a log I could send?
« Last Edit: August 09, 2018, 11:30:07 am by lucasrangit »

 

Page created in 0.05 seconds with 20 queries.

bottleneck