I have my Almond+ running in AP mode and I need to change the MTU from 1500 to 1472 (related to Uverse and IPv6 issues).
However, when I go into the advanced menu, the option to change the MTU for the LAN side seems to be disabled (you can't enter anything / edit).
How can I enable this / change the MTU?
Well you can do it from almond + console, use following commands to get it done.
-->
vi /etc/config/network you will see something like this.....
c
onfig 'interface' 'loopback'
option 'ifname' 'lo'
option 'proto' 'static'
option 'ipaddr' '127.0.0.1'
option 'netmask' '255.0.0.0'
config 'interface' 'lan'
option 'ifname' 'eth0 eth1'
option 'type' 'bridge'
option 'ipaddr' '10.10.10.254'
option 'netmask' '255.255.255.0'
option 'proto' 'dhcp'
Then add one more line in
config 'interface' 'lan' just after
option 'proto' 'dhcp' the line is
option 'mtu' '1496'Next save the script and restart the network using following commands..
etc/init.d/network restartThats it... now you can see, it got changed. Use ifconfig command to check.
Note:-This setting won't be available after reset your device. You have to configure it again.