Choose style:

Author Topic: Full speed repeater  (Read 492 times)

0 Members and 1 Guest are viewing this topic.

Offline anwar.shiekh

  • Newbie
  • ****
  • Posts: 115
  • Thanks: 0
  • Registered : 06/12/2016
    YearsYearsYears
Full speed repeater
« on: May 08, 2019, 02:11:56 pm »
Normally a repeater reduces network speed as it can't talk at the same time it listens, but is it possible to build a full speed repeater using two Almonds? The idea is that one is a bridge and one an AP, BUT with each running on a different (non-overlapping) channel; now the combined unit can talk and listen at the same time.

Offline Shazster

  • Newbie
  • ****
  • Posts: 172
  • Thanks: 0
  • Registered : 29/11/2015
    YearsYearsYearsYears
Re: Full speed repeater
« Reply #1 on: May 09, 2019, 10:56:27 pm »
It's an interesting theory...splitting the TX/RX duties across two units cabled together.

Offline anwar.shiekh

  • Newbie
  • ****
  • Posts: 115
  • Thanks: 0
  • Registered : 06/12/2016
    YearsYearsYears
Re: Full speed repeater
« Reply #2 on: May 11, 2019, 07:15:28 pm »
I am worried about vicinity; although they will be on independent channels the fact that they are very close may mean spill over; then again the 5 MHz separation is large (~12%)

* Channel 36 is 5180 MHz
...
* Channel 165 is 5825 MHz


while for 2.4 MHz

* Channel 1 2412 MHz

* Channel 11 2462 MHz

yields ~2% seperation
« Last Edit: June 30, 2019, 03:45:31 pm by anwar.shiekh »

 

Page created in 0.063 seconds with 21 queries.

bottleneck