Hey,
Got my router yesterday
After updating to the latest r66 fw I'm pretty happy with it so far, although I've not done much with it yet other than setting it up as an AP and attached one binary switch.
Anyhow, to the point:
The binary switch(es) is a Greenwave 6 outlet power strip (Greenwave powernode). Details below:
I can successfully add it the almond + as a sensor. In r64 I could control it via the Android app while in r66 I cannot. However it works via the web page, I also see power reported in r66, but it seems to only update it once.
My issue is however is that there are 6 binary switches with power usage report in the power strip but it can only control one, basically it seems like it can only pair one.
Question is if the pairing logic in the greenwave powerstrips assumes the controller (Almond + in this case) can pair the remaining 5 binary switches based on the first one or if is using a Z-wave command that the almond does not support yet?
Summary of my issues:- Can only control 1 switch out of 6
- Power is reported once (just after pairing) and not updated ever again