Choose style:
« previous next »
Pages: [1]   Go Down

Author Topic: Almond plus and regular almond as WAP  (Read 5729 times)

0 Members and 1 Guest are viewing this topic.

Offline Dudeness30

  • Backer
  • *
  • Posts: 70
  • Thanks: 0
    • Registered : 01/09/2014
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Almond plus and regular almond as WAP
« on: September 01, 2014, 10:33:18 pm »
I have my almond plus as my main router and my regular almond connected to it by Ethernet cable. I have done a factory reset and rebooted both of them however the almond says not connected to the internet. Is there settings I need to change to make the almond work as a WAP.
Logged
Almond+, 2 flood sensors, 1 motion sensor, 1 Z-wave water valve, 2 Aeon Labs DSC06106-ZWUS - Z-Wave Smart Energy Switch, 1 Enerwave ZWN-RSM1S Z-Wave Relay, 1 GE Z-Wave Outdoor Module, 1 Enerwave ZWN-RSM2 Z-Wave Smart Dual Relay,

LGNilsson

  • Guest
Re: Almond plus and regular almond as WAP
« Reply #1 on: September 01, 2014, 11:31:12 pm »
The problem here is that both routers would be in the same default IP address, i.e. 10.10.10.254.
The easy solution for this problem is to set the Almond up in AP (Access Point) mode via the LCD UI, as it'll then get an IP address from your Almond+.
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.067 seconds with 18 queries.